User manual ZANUSSI ZFC22/8FRD

[. . . ] Ice lollies can cause frost burns if consumed straight from the appliance. these should be punctured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. [. . . ] The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the symbol are recyclable. Use The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. The inner lining of the appliance consists of channels through which the refrigerant passes. If 14 CONTENTS Installation Location Rear spacers Cleaning the interior Door reversal directions Fitting the door panel 16 16 16 17 18 18 GB Technical specification Electrical connection 19 19 Use Start-up - Temperature regulation Food refrigeration Hints for correct use Movable wire shelves Positioning the door shelves Defrosting Refrigeration of drinks 20 20 20 20 21 21 22 22 Maintenance Periodic cleaning Periods of non-operation Interior light bulb 23 23 23 23 Servicing 23 15 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. GB Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Fig. 3b D162 Fitting the door panel (for models equipped with door frame) To fit the door panel, proceed as follows: ­ remove the fixing screws and remove the frame side opposite the handle; ­ loosen, without removing them, all remaining screws fixing the door frame; ­ insert the panel from the side on which the frame has been removed and push it fully in; ­ refit the frame side and tighten all the screws. Note The panel size should be 1-2 mm smaller than the door; the maximum permissible panel thickness is 4 mm. 18 TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. 19 USE Start-up - Temperature regulation After plugging in the appliance, turn the thermostat knob, located at the top right of the fridge, clockwise to the required position (beyond position «O» - off). Temperature is kept constant automatically and can be increased by turning the knob to lower numbers, or reduced by turning it to higher numbers. Proper setting is achieved by bearing in mind that the temperature inside the fridge depends on the following factors: room temperature; number of times the door is opened; amount of food stored; location of the appliance. To turn the appliance off, set the thermostat knob to «O». At the lowest temperature setting, when the appliance is full and room temperature is high, the compressor may operate continuously and frost forms on the evaporator of the frezeer compartment. In this case, turn the knob to a less cold setting so that the evaporator can be automatically defrosted with a lower power consumption. GB Food refrigeration To achieve the best results with the refrigerator compartment, you should follow one or two very simple rules: Do not put warm foods or evaporating liquids in the refrigerator. [. . . ] 6 D066 21 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough (Fig. 7) into a special container on the back of the appliance where it evaporates. Clean periodically the water drain hole (Fig. [. . . ]