User manual ZANUSSI ZFC282C

[. . . ] REFRIGERADOR REFRIGERATOR FRIGORIFICO ZFC 282 C LIBRO DE INSTRUCCIONES 2222 151-15 INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cleaning the appliance's interior . Changing the opening direction of the door . [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Make sure that there is nothing hindering air circulation at the back, bottom, or top of the appliance. To achieve the best performance when the appliance is set under a wall cabinet the top of the appliance should be at least 5 mm away from the base of the cabinet (Fig. However, the appliance should ideally not be installed underneath wall cabinets (as shown in Fig. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. 1 5mm Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly. Do not use detergents or abrasive powders as these will damage the finish. A B D174 12 Changing the opening direction of the door Unplug the appliance before performing the following operations: Remove the ventilation grille (D-Fig. 2 Reverse the direction of the handle. 3a E F G D F D071 G D162 Changing the opening direction of the compartment door (Fig. Pin (4) could drop out when this operation is carried out; if so, it must be retrieved for fitting on the opposite side. Remove bush (5) and fit it on the opposite side. Remove the catch (3) and fit it on the opposite side. Reposition the door and insert pin (1), pressing it into place. 4 C B A Remove the door from the upper pivot (A-Fig. [. . . ] This tray should be filled with drinking water and then placed in the evaporator compartment. Do not use metal tools to remove the tray when it is stuck-frozen inside the compartment. 15 Defrosting While in operation, the refrigerated surfaces of the evaporator become progressively covered with frost. This frost, which acts as a thermal insulator and thus prevents the cold from reaching the food, should be removed at regular intervals, otherwise, there will be a marked rise of temperature in the compartment concerned and a wastefull increase in power consumption. To carry out complete defrosting push the button at the centre of the thermostat knob (Fig. [. . . ]