User manual ZANUSSI ZFC282R

[. . . ] Children should not be allowed to tamper with the controls or play with the product. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 32 Changing the opening direction of the door Unplug the appliance before performing the following operations: Remove the ventilation grille (D-Fig. Remove the screws of the bracket with foot (I) and levelling foot (H) and reassemble them on the opposite side (Fig. Remove the door from the upper pivot (A-Fig. Remove the pivot and the washer (A+B-Fig. 5) from the upper hinge (C), then mount these on the opposite side. 4) on the opposite side, using the screws previously removed. To do this, press it in the direction of the arrow. Insert the plug (G), which is supplied with the appliance, into the hole left free on the opposite side. Reverse the direction of the handle (Fig. 5 C B A Warning After having reversed the opening direction of the door, check that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D427 Fig. 6 D162 33 Changing the opening direction of the compartment door (Fig. Pin (4) could drop out when this operation is carried out; if so, it must be retrieved for fitting on the opposite side. Remove bush (5) and fit it on the opposite side. Remove the catch (3) and fit it on the opposite side. Reposition the door and insert pin (1), pressing it into place. 4 3 Fig. [. . . ] Clean cabinet outer surfaces with a silicone-wax spray. The condenser and compressor should be cleaned using a brush or a vacuum cleaner. This latter operation will maintain the appliance's excellent standards of performance and save energy. To avoid water spillage it is recommended that the water drain collector (Fig. [. . . ]