User manual ZANUSSI ZFC28DR

[. . . ] These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product. [. . . ] 1 100 mm min. A 45° D060 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A B D042 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 12 Door reversal Unplug the refrigerator from the wall socket before performing the following operations: Remove the lower hinge (3), the pin (1), the spacer (4) and the support foot (2). Unscrew the front left support foot and screw it into the corresponding position on the opposite side. Unscrew the two screws which hide the fixing holes of the hinge on the left-hand side. Detach the lower door from the central hinge (5). Remove the central hinge and detach the upper door from the pin (6). Unscrew the pin (6) and screw it into the corresponding position on the opposite side. Remove the two plugs, and remount them on the other side. Re-assemble the upper door, the central hinge and the lower door. Re-assemble the lower hinge (turning it 180°), the spacer (4), the pin (1) and the support foot (2) on the opposite side. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. [. . . ] After two or three hours, reload the previously removed food into the compartment. Important: A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. D037 16 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. The maximum rating is shown on the light cover. [. . . ]