User manual ZANUSSI ZFC45-30SS

[. . . ] Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. [. . . ] Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials; it must nevertheless be disposed of in a proper manner, in accordance with regulations for protection of the environment. 10 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. 2 Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For more efficient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (Fig. 1-B (without overhanging kitchen furniture). in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D162 D547 D548 Fig. 3b Fitting the door panel (for models equipped with door frame) To fit the door panel, proceed as follows: ­ remove the fixing screws and remove the frame side opposite the handle; ­ loosen, without removing them, all remaining screws fixing the door frame; ­ insert the panel from the side on which the frame has been removed and push it fully in; ­ refit the frame side and tighten all the screws. Note The panel size should be 1-2 mm smaller than the door; the maximum permissible panel thickness is 4 mm. 12 USE Start-up - Temperature regulation After plugging in the appliance, turn the thermostat knob, located at the top right of the fridge, clockwise to the required position (beyond position «O» - off). Temperature is kept constant automatically and can be increased by turning the knob to lower numbers, or reduced by turning it to higher numbers. Proper setting is achieved by bearing in mind that the temperature inside the fridge depends on the following factors: room temperature; number of times the door is opened; amount of food stored; location of the appliance. To turn the appliance off, set the thermostat knob to «O». At the lowest temperature setting, when the appliance is full and room temperature is high, the compressor may operate continuously and frost forms on the evaporator of the frezeer compartment. In this case, turn the knob to a less cold setting so that the evaporator can be automatically defrosted with a lower power consumption. D040 Hints for correct use Raw meat: wrap in polythene bags and place on top of the salad crisper and, for safety, only store in this way for one or two days at the most. Cooked foods, cold dishes, etc. : these should be covered and stored on the fridge shelves. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom salad crisper. [. . . ] Remoção de gelo Manutenção . Conselhos para um uso correcto . Colocação das prateleiras da porta . Limpeza periódica . Longos períodos sem funcionar . Lâmpada de iluminação . [. . . ]