User manual ZANUSSI ZFC47-51FF

[. . . ] . Operation . Temperature regulation . . Periodic cleaning . Periods of non-operation. . Customer Service and spare parts . 34 Printed on recycled paper WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. [. . . ] The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. For freezers only (except built-in models): an ideal location is the cellar or basement. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer. 35 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Fig. 4 D162 Inner door reversal (Only for model ZFC 1503 S) Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. 5) and withdraw it from its seat together with the door; remove plug (2) and fit it in the hole left open on the opposite side; turn the door through 180°, remove the bracket (1) and refit it on the opposite side. Refit the door and insert the top pin and bottom bracket (1), pushing it into place. To ensure correct storage of food, the door is fitted with a simple spring device which holds it in the open position until it is properly closed. PR140 Fig. 5 180° 2 1 37 Aligning the worktop of the appliance with the kitchen furniture The appliance worktop is aligned with the door. It can however be easily aligned to the kitchen furniture by proceeding as follows: unscrew the screws on the upper hinges that fasten the worktop to the appliance. Move the worktop to the desired position and tighten the screws again. Important For the appliance to function properly, an opening of at least 137 cm2 (Fig. A minimum clearance must also be provided between the condenser and the wall, as shown in the Fig. [. . . ] To stop operation, simply turn the thermostat knob to position «O». Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Storage of frozen food (Only for model ZFC 1503 S) The compartment marked is suitable for long-term storage of frozen and deep-frozen food. When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position. [. . . ]