User manual ZANUSSI ZFD19/4

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation There are working parts in this product which heat up. [. . . ] 3a) after having removed the plugs which mask the holes. The plugs must be refitted in the holes left open on the opposite side. Unscrew the lefthand levelling foot, which will be refitted on the opposite side. Unscrew the right-hand levelling foot (H), the corresponding hinge (I) and the stop (L) and refit all these on the left-hand side (Fig. Reverse the handles after having removed the clip-in screw covers. The unused holes are masked with plastic plugs which should be removed and refitted in the holes left open. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D045 Fig. 3b L I Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. H D537 Fig. 3c D336 TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB 6 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise, beyond the «O» (STOP) position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable. However, the thermostat knob setting should be adjusted depending on the temperature required inside the appliance. This, in turn, depends on a number of factors such as the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Turn the knob clockwise, to higher numbers, to obtain a lower temperature, or anticlockwise if a higher temperature is required. GB Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer. [. . . ] If it still does not light up, change the bulb. The rating is shown on the light bulb cover. 7 External cleaning Wash the outer cabinet with warm soapy water. Once or twice a year dust the condenser (black grill) and compressor at the back of the appliance with a brush or vacuum cleaner. [. . . ]