User manual ZANUSSI ZFD29/8LR

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] If an option which is not compatible with the set wash programme is selected, the message Err is displayed for few seconds and the red light of this button flashes for 3 times. Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash phase, pour it into the compartment marked . If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green light of button 8 starts blinking. It can be turned either clockwise or anticlockwise. On position «O» the programme is reset and the machine is switched OFF. At the end of the programme the selector dial must be turned to position «O», to switch the machine off. 16 Select the delayed start by pressing the button 6 Press this button to select the required delay. The selected delay time value will appear on the display for few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 6 once. After few minutes the door can be opened 17 (Pay attention to the water level and temperature!). After closing the door, it is necessary to set the programme and the options again and then to press button 8. At the end of the programme The machine stops automatically. Some acustic signals sound and on the display will appear «0. 00 ». The pilot light of the button 8 and the pilot light 9 go off. If at the end of a programme there is water in the tub (pilot light 9 on and door locked), to empty out the water follow the following instructions: To empty out the water: 1. turn the programme selector dial to «O» 2. select the «Drain»or «Spin» programme 3. reduce the spin speed, if needed, by means of the button 3 4. at the end of programme, the display shows «0. 00», the pilot light 9 goes off and it will be possible to open the door. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. [. . . ] Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i. e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked. Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». [. . . ]