User manual ZANUSSI ZFD29/8T

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, cleaning and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] Indicator lights ( 8 ) After having pressed the button 6 , the «Wash» pilot light illuminates and stays on while the machine is working. At the end of any cycle it goes off. 2. 05 Start the programme by pressing the button 6 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The «Wash» and «Door» lights illuminate to indicate that the appliance starts operating and the door is locked. To interrupt a programme which is running, press the button 6 : the corresponding green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press this button again. If you have chosen a delayed start, the machine will begin the countdown. If an incorrect option is selected, the red pilot light of this button flashes 3 times and the message Err is displayed for a few seconds. Select the Delay Start by pressing the button 7 Before you start the programme, if you wish to delay the start, press the button 7 repeatedly, to select the desired delay. The selected delay time value (up to 20 hours) will appear on the display for a few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 6 . 16 Operating sequence When the programme has finished, the «End» pilot light illuminates and at the same time the light of the button 6 goes off. At the end of the programme The machine stops automatically. On the display will appear a flashing «0. 00» and the door can be opened. If the «Rinse hold» or «Night Cycle» option has been selected, the display will show a flashing «0. 00» and the door remains locked to indicate that the water must be emptied out before opening the door. To empty out the water proceed as follows: 1. turn the programme selector dial to «Off» 2. select the Drain or Spin programme 3. reduce the spin speed if needed, by pressing the relevant button 4. press the button 6 to start the selected programme 5. at the end of programme, only the «End» light illuminates. Now it is possible to open the door. 17 Turn the programme selector dial to «Off» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. [. . . ] Sprung wooden floors are particularly susceptible to vibration. If possible, always place the machine on a solid floor. 28 SINK BATH TOILET BIDET WASHING MACHINE RAINWATER 'RUN-OFF' DISHWASHER FOUL DRAIN SURFACE WATER DRAINS & SEWERS FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHARGE RIVER RIVER UNTREATED DISCHARGE Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The manufacturer declines any liability should this safety measure not be observed. [. . . ]