User manual ZANUSSI ZGF648IR

[. . . ] GAS HOB ZGF 643 ZGF 648 INSTRUCTION BOOKLET RU ENGLISH Important Safety Information These warnings are provided in the interest of safety. You installing or using the appliance. MUST read them carefully before During Operation · It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. This appliance has been designed for non professional purpose in private houses only. [. . . ] Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. In models provided with electric ignition, this feature is obtained through a ceramic "candle" and a metal electrode (Fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. B) are not obstructed. FO 2237 Pan supports To keep the pan supports in the right position, they are hooked to a couple of special hinges in the back of the hob. Thanks to these hooks, you can lift the pan supports for easier cleaning, as shown in Fig. To take the pan supports completely off the hob, proceed as shown in Fig. 3. Cast iron pan supports (ZGF 643 ITXC) Caution!When removing the cast iron pan supports, lift them up as shown in Fig. Never turn the pan supports on the hinges as shown in Fig. 2, since this could damage them. FO 2238 Fig. 2 Periodic Maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. · The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. Fig. 3 Technical data Gas Burners Rating Rapid Burner (big) 3, 0 kW (G20) - 2, 8 kW (G30-31) Semirapid Burner (medium) 2, 0 kW Auxiliary Burner (small) 1, 0 kW Class 3 Appliance Category II 2E+3+ Setting Natural Gas 20 mbar / G25 25 mbar Gas connection G 1/2" Electric Supply 230 V 50 Hz Hob recess dimensions Length Width 560 mm. 480 mm. Instruction for the Installer · The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. · Avoid installing the appliance in the proximity of inflammable materials (e. g. · The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The regulation to be applied for this type of installation is NBN D 5I. 003 : "Installations functioning with combustible gas lighter than air". · The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. Gas connection It is indispensible that the connection to the gas mains are carried out by means of an AGB tap. [. . . ] 9 58 0 51 0 A = Auxiliary burner SR = Semirapid burner R = Rapid Burner These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. 9. Fitting the lid We recommend the lid hinge block are fitted before installing the hob into the worktop. To install the lid onto the hob, proceed as follows: a. Remove the right and left hand grid blocks fitted to the back of the hob, by unscrewing the relevant screws (Fig. [. . . ]