User manual ZANUSSI ZGG646ICY

[. . . ] Children should be KEPT AWAY until it has cooled. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service Centre. [. . . ] Cleaning and Maintenance · Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. Regularly wipe over the hob top using a soft cloth weel wrung out in warm water to which a little liquid detergent has been added. Avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for non-stick saucepans; - steel wool pads; - bath/sink stain removers. Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used. The electric ignition is obtained through a ceramic "candle" and a metal electrode (fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. PERIODIC MAINTENANCE Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. q The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. FO 2111 Fig. Technical Data Gas Burners Rating Rapid Burner (big) Semirapid Burner (medium) Auxiliary Burner (small) Category Setting Gas connection 2, 9 kW 1, 9 kW 1 kW II 2ELL 3 B/P Natural Gas 20 mba G 1/2" Electric Supply HOB RECESS DIMENSIONS Length Width 550 mm. Instruction for the Installer q The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. q Avoid installing the appliance in the proximity of inflammable materials (e. g. q The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The regulations to be applied for this type of installation are: -- DVGW-TRG '86 "Technical standard for the installation of gas appliances"; -- TRF 1988 "Technical standard for LPG"; q The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. GAS CONNECTION It is indispensible that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel). If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. This hob can be operated by natural gas with nominal pressure of 20 mbar. No regulation is required for use by these two types of gas. [. . . ] If changing from natural gas "E" to natural gas "LL", undo the by-pass screw until a small regular flame is obtained. 10. Fig. 9 FO 2108 A a) Sealing gasket Fig. 10 FO 2107 9 POSSIBILITIES FOR INSERTION Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig. The panel fitted under the hob should be easily removable to allow an easy access if a technical assistance intervention is needed. Kitchen unit with oven The hob recess dimensions must comply the indication given in Figs. [. . . ]