User manual ZANUSSI ZGG659ICWC

[. . . ] Do not allow children to play near or with the appliance. The appliance gets hot when it is in use. Children should be kept away until it has cooled. [. . . ] 1 FO 2295 A - Burner cap B - Ignition candle C - Thermocouple If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat. As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. If the control knobs become difficult to turn, please contact your local Service Centre. Using the hob correctly To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (See table). Burner Large (rapid) Medium (semi-rapid) Small (Auxiliary) minimum diameter 160 mm 120 mm 80 mm maximum diameter 240 mm 220 mm 160 mm 5 Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top and the aluminium frame using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for non-stick saucepans; - steel wool pads; - bath/sink stain removers. Fig. 2 FO 2110 Pan Supports The pan supports are dishwasher proof. If necessary, remove stubborn stains using a paste cleaner. Never use steel wool pads or acids. The Burners The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth. The cap and crown of each burner are secured with two screws. To separate the two pieces, lift the crown, turn it upside down, then undo the two fixing screws as shown in Fig. After cleaning, reassemble the two parts and refit the cap on its correct position on the burner. Fig. 3 FO 2265 6 Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM There is no spark when lighting the gas SOLUTION Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB has not tripped (if fitted) Check the burner cap and crown have been replaced correctly, e. g. after cleaning. The gas ring burns unevenly Check the main jet is not blocked and the burner crown is clear of food particles. [. . . ] 3) Fit the hob in the cut out and push it down until the glass top and the working top make contact, as shown in figure 7. 6 FO 2108 A Electrical connection FO 2107 Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person, in accordance with the current regulations. 7 Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm. [. . . ]