User manual ZANUSSI ZGL63IX

[. . . ] It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. A build-up of fats or other foodstuff could result in a fire. Under no circumstances should you attempt to repair the appliance yourself. [. . . ] Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. Regularly wipe over the hob top using a soft cloth weel wrung out in warm water to which a little liquid detergent has been added. Avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for non-stick saucepans; - steel wool pads; - bath/sink stain removers. Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used. The electric ignition is obtained through a ceramic "candle" and a metal electrode (fig. 1-lett. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes are not obstructed. ZGL 63 ITCX: The cap and crown of each burner are secured with two screws. To separate the two pieces, lift the cap, turn it upside down, then undo the two fixing screws as shown in fig. After a thorough cleaning, reassemble the two parts and refit the cap in its correct position on the burner. Fig. 3 FO 2110 Periodic Maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. Use some soapy water, never a flame. A) Ramp with ending nut B) Seal C) Adjustable connection FO 2365 Fig. 5 32 Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. To connect the plug to the cable, follow the recommendation given in Fig. The plug has to be fitted in a proper socket. If connecting the appliance directly to the electric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a temperature 50 °C higher than the room temperature. [. . . ] 1/100 g/h - G30 50 71 86 72 145 203 g/h - G31 71 143 200 m3/h 0, 095 0, 190 0, 286 Auxiliary Semi-rapid Rapid 1 2 Natural gas : 3 LPG : 2, 8 0, 33 0, 45 0, 65 70 96 119 34 Building In R SR SR A 58 0 58 Fig. 9 Dimensions are given in millimeters R SR SR A 5 00 0 50 0 These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. is fitted over the hob, the hanging furniture units beside the hood must be placed at 550 mm. [. . . ]