User manual ZANUSSI ZH6010B/E

[. . . ] The paper filters have saturation indicators and should be located on the internal side of the grille with the spots facing outwards. Worktop illumination consists of a fluorescent strip light or of two lamps. 3 4 IDENTIFICATION OF THE APPLIANCE The rating plate is situated inside the casing. It gives the model number and serial number which should be quoted in any communication or if After Sales Service is required. 5 6 PRODUCT This cooker hood has been designed for the purification of contaminated air and to remove odours in the kitchen. ATTENTION: This cooker hood must not be used for the purification of air which could contain harmful gases or poisons or other substances not to be found during normal cooking. 7 8 SAFETY WARNINGS ATTENTION: Before carrying out any kind of maintenance or cleaning disconnect the hood from the mains supply and unplug the cooker hood. Connect the hood to the mains supply via a double pole switch which has 3mm minimum clearance between the contacts. 9 10 Before connecting this appliance to the mains supply, ensure that the mains voltage corresponds to the voltage on the rating plate inside the hood. This appliance must be earthed. ATTENTION: Only use earthed plugs or sockets. ATTENTION: Do not use any adapters or extensions. 11 12 When used in the extraction mode the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric such as a central heating flue or water heating flue. When installed, the hood must be positioned at least 65cm above a cooking appliance. Never do flambè cooking under this cooker hood. When using a gas hob in conjunction with this cooker hood never leave the burners of the hob uncovered while the hood is in use, or when the pans have been removed. [. . . ] When using a gas hob in conjunction with this cooker hood never leave the burners of the hob uncovered while the hood is in use, or when the pans have been removed. Switch off the gas before removing the pan, or for just short periods and never leave the hob unattended. 13 14 Never leave frying pans unattended during use as overheated fat and oil may catch fire. If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted ensure that there is an adequate supply of air to the room. The cooker hood in fact could extract the air which is needed for burning. When the cooker hood and appliances supplied with energy other than electricity are simultaneously in operation the negative pressure in the room must not exceed 0, 04 mbar in order to avoid a return of the gaz emissions. This is possible through openings in doors, windows, or air inlet valves allowing fresh air to enter the kitchen. In any case, in connection with the discharge of exhaust air, the requirements of the authorities concerned have to be observed. 15 16 Always ensure that the flame is kept at the correct intensity to prevent the flame from licking round from the bottom of the pan; this will save energy and will avoid a dangerous concentration of heat. ATTENTION: There could be a possible fire hazard if the grease filters are not cleaned or replaced when necessary and according to these instructions. The grease filters and charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently for more than 4 hours per day. 17 18 ATTENTION: Please read the instruction booklet carefully before installing or using this appliance. ATTENTION: Do not insert hands or any other object into the air outlet. Do not use wet clothes or sponges to clean the surfaces of the cooker hood. 19 20 Should your cooker hood fail to function at anytime repairs should be carried out by a qualified electrician or a competent person. When carrying out any kind of maintenance or in the event that your cooker hood stops functioning, switch off the mains supply and disconnect the plug from the socket. The internal diameter of the ducting used should be the same than the external diameter of the ducting spigot. Now ducting installation is completed. 39 40 ELECTRICAL CONNECTION ALLACCIAMENTO ELETTRICO Before connecting this appliance to the mains supply, ensure that the mains voltage corresponds to the voltage on the rating plate inside the hood. Verificare che la tensione di rete corrisponda a quella riportata sulla targhetta delle caratteristiche tecniche della cappa. WARNING: This appliance must be earthed. ATTENZIONE: Verificare che la presa di rete sia predisposta di messa a terra, in caso contrario provvedere. Insert the plug in the socket. Inserire quindi la spina nell'apposita presa di rete. Switch on the power to the cooker hood at the socket on the wall. Now the cooker hood is ready to be used. Portare l'interruttore di linea in posizione "1". A questo punto l'apparecchio di aspirazione è pronto all'uso. 41 42 CONTROLS M POS. DESCRIPTION C S V M L Visor Control box Fan speed selector switch Fan motor ON/OFF switch Worktop lighting ON/OFF switch 43 44 SWITCHING THE APPLIANCE ON AND OFF Switch on the power to the cooker hood at the socket on the wall. Lower the control box as illustrated. To switch on the fan slide the switch marked "M" to position "1". 45 46 To select the fan speed required, slide the switch marked "V". To switch on the worktop lighting slide the switch marked "L" to position "1". At this point all the functions of the cooker hood have been demonstrated. If desired the control box can be closed during cooking. The movement of the visor can be used to switch the appliance on and off if the controls were left switched on from the last operation. 47 48 MAINTENANCE AND CLEANING To ensure the best performance from your cooker hood when used in the recirculation mode charcoal filters should be replaced at least every 3 months. Metal filters should be cleaned at least every two months. The filters may be washed by hand in hot water using mild detergent or liquid soap or they can be machine washed in a dishwasher. The paper filters have saturation indicators and the filters should be replaced when the red dots start to spread over the whole surface of the filter, or at least every 2 months. 49 50 To replace the paper filters, remove the grille panels and the metal retaining clips. Place the new filter on the grille with the coloured dots facing downwards. To replace the fluorescent strip light or the two lamps (60cm and 90cm cooker hoods) proceed as follows: Disconnect the hood from the mains supply. Unplug the cooker hood. Remove the screws on the plastic terminal near the lighting diffuser. 51 52 Move the glass strip until the opposite end is free. [. . . ] The filters may be washed by hand in hot water using mild detergent or liquid soap or they can be machine washed in a dishwasher. The paper filters have saturation indicators and the filters should be replaced when the red dots start to spread over the whole surface of the filter, or at least every 2 months. 49 50 To replace the paper filters, remove the grille panels and the metal retaining clips. Place the new filter on the grille with the coloured dots facing downwards. To replace the fluorescent strip light or the two lamps (60cm and 90cm cooker hoods) proceed as follows: Disconnect the hood from the mains supply. Unplug the cooker hood. Remove the screws on the plastic terminal near the lighting diffuser. 51 52 Move the glass strip until the opposite end is free. Pull the glass strip slightly down. Move the glass strip towards one side and remove. [. . . ]