User manual ZANUSSI ZHC631AL

[. . . ] · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] For the upper fixing position, proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. · Mark the centres of the two holes in the upper plate. · Drill ø 8 mm holes at all the centre points marked. 650 min. X 7. 2. 1 15 GB · Insert the wall plugs 11 in the holes. · Fix the brackets using the 12a screws supplied. · Insert the two screws 12a supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. · Fix the back panel (where present) using the 12a screws (4, 2 x 44, 4) supplied. Mounting the hood body · Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points · Hook the hood body onto the screws 12a · Fully tighten support screws 12a · Adjust screws Vr to level the hood body Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Remove any activated charcoal filters. ø 150 9 ø 120 GB 16 RECIRCULATION VERSION AIR OUTLET · Assemble the two halves of the hood body extension piece 14 · Push fit the assembled hood body extension piece 14 onto the air outlet · Push fit connection 15 onto the hood body extension piece 14 · Insert the connection extension pieces laterally 14. 1 in connection 15 · Make sure that the outlet of the extension pieces 14. 1 is horizontally and vertically aligned with the chimney outlets. · If this is not the case, adjust the position by either reversing the connection extension pieces 14. 1 or by cutting the hood body extension 14 along one of the thinner section channels denoting the pre-fixed lengths, then reassemble as described previously. · The air outlet directional grills must be fitted after the lower outlet duct has been installed · Ensure that the activated charcoal filters have been inserted. 15 8b 8a 14 14. 1 ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Flue assembly Upper exhaust flue · Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 2. 1, making sure that they are well seated. · Secure the sides to the brackets using the 4 screws 12c supplied. Lower exhaust flue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. · Fix the lower part laterally to the hood body using the 2 screws 12c supplied. [. . . ] · Replace the metal grease filters. 19 GB Quest'apparecchio é conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. [. . . ]