User manual ZANUSSI ZHC634X

[. . . ] · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. For fixing at the top only, proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. · Mark the centres of the two holes in the upper plate. GB H 180 7. 1 110 110 X 7. 2. 1 16 · · · · Drill ø 8 mm holes at all the centre points marked. Fix the brackets using the 12a screws supplied. Fix the back panel (where present) using the 12a screws supplied. Mounting the hood body · Screw the two screws 12d (M4 x 25) supplied onto the brackets 7. 1. · Hook the hood body onto bracket 7. 1, centring it around the vertical line. · Use the adjusting screws 12d underneath the hood to level the hood body. 12. d 7. 1 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Remove any activated charcoal filters. ø 150 9 ø 120 RECIRCULATION VERSION AIR OUTLET · Push fit the air outlet fitting 15 onto the air outlet of the hood body. · The air outlet directional grills must be fitted after the lower outlet duct 2. 2 has been installed · Ensure that the activated charcoal filters have been inserted. 15 17 GB ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Chimney assembly Upper chimney section · Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. 2. 1, making sure that they are properly housed. · Secure the sides to the brackets using the 4 screws 12e (2, 9 x 9, 5) supplied. Lower chimney section · Slightly widen the two sides of the section and hook them between the upper section and the wall, making sure that they are properly housed. · Fix the sides of the bottom section to the hood body using the 2 screws 12e (2, 9 x 9, 5) supplied. [. . . ] · Replace the metal grease filters. 21 GB Quest'apparecchio é conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. [. . . ]