User manual ZANUSSI ZHC9015X

[. . . ] USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] · Mark the wall at the centres of the holes in the bracket. · Place bracket 7. 1 as shown 109, 5 mm from the vertical reference line and 200 mm above the horizontal reference line. · Mark the centres of the holes in the bracket. · Repeat this operation on the other side. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, if it is to be fixed at both top and bottom, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. For fixing at the top only, proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. · Mark the centres of the two holes in the upper plate. GB H 200 7. 1 109, 5 109, 5 X 7. 2. 1 13 · · · · Drill ø 8 mm holes at all the centre points marked. Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied. Fix the back panel (where present) using the 12a (4, 2 x 44, 4) screws supplied. Mounting the hood body · Screw the two screws 12d supplied onto the brackets 7. 1. · Hook the hood body onto the bracket 7. 1, centring it around the vertical line. · Use the adjusting screws 12d underneath the hood to level the hood body. 12. d 7. 1 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer. · To install a ø 125 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Remove any activated charcoal filters. ø 150 ø 125 9 GB 14 RECIRCULATION VERSION AIR OUTLET · Push fit the air outlet fitting 15 onto the air outlet of the hood body. · Ensure that the activated charcoal filters have been inserted. 15 ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. · Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Flue assembly Upper exhaust flue · Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 2. 1, making sure that they are well seated. · Secure the sides to the brackets using the 4 screws 12c (2, 9 x 9, 5) supplied. Lower exhaust flue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. · Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. [. . . ] · Unscrew the bulbs and replace them with new ones having the same characteristics. · Replace the metal grease filters. GB 17 Quest'apparecchio é conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. [. . . ]