User manual ZANUSSI ZHC928X

[. . . ] USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] Push fit the extension piece 14 onto the flange. Push fit connector 15 onto the extension piece. Insert extension piece/connector 14. 1 laterally on connector 15, ensuring that the outlet is in line with the chimney intake. ø 120 15 14. 1 14 9 GB 17 Flue assembly - Mounting the hood body · Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c provided. · Similarly, position the lower chimney section without fixing it, ensuring that the outlet from connector 15 is in line with the chimney intake. · The air outlet directional grill 8 must be fitted after the installation of the chimney. Before fixing the hood body to the frame: · remove the grease filters from the hood body; · remove the activated carbon odour filters, if fitted. · from below, use the 4 screws 12f provided to fix the hood body to the frame. · For the recirculation version, locate the directional grill 8 in its housing. Ensure that it is inserted correctly in connector 15. 12f 8b ELECTRICAL CONNECTION · Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. · Take off the upper protection bracket by unscrewing the screws. · Connect the control connector Cmd. · Reassemble the protection bracket. · Take off the bracket which is opposite to the previous one by unscrewing the screws. · Connect the spotlights connector L. · Reassemble the protection bracket. · For the recirculation version, fit the activated carbon odour filter. · Replace the grease filters. Cmd L GB 18 USE Control panel S1 0-1 S2 S3 T1 T2 T3 15 30 0-1 S4 S5 R reset reset L V1 delay 60 V2 V3 V4 V5 T L S1 S2 S3 S4 S5 Light Led Led Led Led Led R V1 V2 V3 V4 Reset Motor Speed Speed Optimum speed V5 Intensive speed T Delayed shutdown T1 T2 T3 Led Led Led Switches the lighting system on and off. Activated charcoal filter exhausted alarm led. To disable this indicator (Ducted hoods) simultaneously press buttons R (using a sharp object, for example a pencil) and V2. To enable it again, press buttons R and V3. Switches the extractor motor on and off. [. . . ] · Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. · Replace the ring nut and fix it in place using the two screws removed as above. GB 21 Quest'apparecchio é conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. [. . . ]