User manual ZANUSSI ZHC930X

[. . . ] · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe using the pipe clamps 25 provided. · Remove any activated charcoal filters. 9 ø 150 RECIRCULATION VERSION AIR OUTLET · · · · Insert reducer flange 9 on the extractor outlet. Push fit the extension piece 14 onto the flange. Push fit connector 15 onto the extension piece. Insert extension piece/connector 14. 1 laterally on connector 15, ensuring that the outlet is in line with the chimney intake. ø 120 15 14. 1 14 9 GB 18 Flue assembly - Mounting the hood body · Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c provided. · Similarly, position the lower chimney section without fixing it, ensuring that the outlet from connector 15 is in line with the chimney intake. · The air outlet directional grill 8 must be fitted after the installation of the chimney. Before fixing the hood body to the frame: · remove the grease filters from the hood body; · remove the activated carbon odour filters, if fitted. · from below, use the 4 screws 12f provided to fix the hood body to the frame. · For the recirculation version, locate the directional grill 8 in its housing. Ensure that it is inserted correctly in connector 15. 12f 8b ELECTRICAL CONNECTION · Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. · Connect the control connector Cmd. · Place the connector in the junction box 24 and close it using the 4 screws 12e provided. · Fix the junction box to the hood body using the 2 screws 12c provided. · For the recirculation version, fit the activated carbon odour filter. · Replace the grease filters. 24 12e Cmd 12c 19 GB USE Control panel L S1 M V1 V2 S2 V3 L Light Switches the lighting system on and off. [. . . ] · Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. · Replace the ring nut and fix it in place using the two screws removed as above. GB 22 Quest'apparecchio é conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. [. . . ]