User manual ZANUSSI ZHP610W4

[. . . ] 2. 3 - Connect the cooker hood to the mains via a bipolar switch which has 3 mm clearance between the contacts. 2. 5 - When installed, the hood must be positioned at least 65 cm above the hotplate. 2. 6 - Never do flambé cooking under this cooker hood. [. . . ] 2. 8 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 2. 9 - If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 3 - INSTALLATION 3. 1 - Installation with screws 1234The bottom of the cabinet must be placed at 135mm from the lower edges (fig. The installer may choose one of the two sets of pre-drilled holes on the upper part of the canopy hood (fig. Drill 4. 5mm Ø holes on the bottom of the cabinet in line with the chosen set of holes. Fix the cooker hood by using 4, 2x44, 4 four screws supplied (fig. 3). 3. 2 - Installation with butterfly quick fixing system 1- The cooker hood can be provided with the butterfly quick fixing system S (fig. If the cooker hood is provided with this method of fixing the hood can be installed into the wall cabinet with the bottom in its normal position. · medium speed, should be selected for normal cooking. This speed offers the best ratio between air capacity and noise level. · top speed, should be selected when frying or cooking food with strong odours, even for a long period. A microswitch operated by the movement of the visor controls the functioning of the appliance in the previously selected conditions. 3 - MAINTENANCE Regular maintenance and cleaning will ensure good performance and reliability, while extending the working life of the hood. Special attentions should be paid to the grease filters. 3. 1 - Metal grease filters 1 - Cleaning The metal grease filter should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using mild detergent or liquid soap. 2 - Replacement Open the pull-out visor and push the lateral knobs of the filter towards the centre while pulling downwards (fig. Refit the filter with the handle on the visible part of the hood. 3. 2 - Synthetic fibre filter 1 - This type of filter is printed with red dots. When the filter becomes saturated the red colour of the dots will spread over the whole surface of the filter. At this point the filter has to be replaced. The saturated filter cannot be cleaned or regenerated. [. . . ] The saturated filter cannot be cleaned or regenerated. 2 - Replacement a - Open the metal grille pushing the knobs towards the centre while pulling downwards (fig. b - Remove the wire clips and replace the synthetic fibre filter (fig. [. . . ]