User manual ZANUSSI ZHP612WM

[. . . ] The installation work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air. The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text. 2 - SAFETY WARNINGS 2. 1 - When used in the extraction mode, the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric, such as a central heating flue or water heating flue. [. . . ] 4 - Finally fix the hood by turning the screws of the brackets S placed on the lower part of the appliance (fig. 5 - To remove the hood from the cabinet loosen the securing screws anti-clockwise. In this position the catches of butterfly brackets S are in the closed position and the hood can be removed from the opening. 3. 3 - Installation of the wall infill spacer After having fixed the hood to the cabinet, a supplied metal wall infill spacer can be fitted on the lower part to close up the space between the back edge of the hood and the wall (fig. 7). 3. 4 - Ducting to the remote blower The hood must be ducted to the remote blower using either a rigid or a flexible duct Ø 150mm (fig. In this case it will be necessary to fit a Ø 150-120mm adapter to the hood outlet. If the remote blower is installed inside the home, it must be ducted to the outside. 3. 5 - Electrical connection and working test 1 - Safety measures 2. 2, 2. 3 and 2. 4 of paragraph 2 must be strictly observed. 2 - Once the electrical connection has been completed, check that the worktop illumination, motor and speed adjustment work properly. After installation of the hood, the sliding visor should be opened for the first time using a certain amount of force, until the click indicating maximum extension is heard. Part 2 - USE AND MAINTENANCE INSTRUCTIONS 1 - SAFETY WARNINGS It is most important that all the warnings shown in paragraph 3 of part 1 are strictly observed. Moreover, special attention must be paid to the following warnings during the use and maintenance of the cooker hood: 1. 1 - The grease filters and the charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (more than 4 hours per day). 1. 2 - When using a gas hob in connection with the cooker hood never leave the burners of the hob uncovered while the hood is in use or when the pans have been removed. Switch off the gas before removing the pan or for just short periods and never leave the hob unattended. 1. 3 - Always ensure that the appliance is kept at the correct intensity to prevent the flame from licking round from the bottom of the pan; this will save energy and will avoid a dangerous concentration of heat. [. . . ] These lamps can be reached by removing the glass visor (fig. b - Should the two lamps fail to work, open the metal grille and ensure they are correctly screwed into the holder. [. . . ]