User manual ZANUSSI ZHT660W

[. . . ] Use an outlet pipe with: minimum indispensable length; - Minimum possible bends (maximum angle of bend:90); - certified material (according to the State); - an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe cross-section (recommended diameter: 125 mm). For air evacuation to the outside, follow all the instructions given on the "Warnings" sheet. Decide on the position of the hole for the air outlet: The hole may be in the wall or the ceiling, according to your requirements, but must be in vertical line with your hob. [. . . ] Push the hood up against the wall unit and insert the 4 screws operating from inside the wall unit (the 4 screws are not provided). Connect a flexible tube to the hood flange, using a metal hose clamp. We recommend you: CHECK THAT THE DUCTING-FILTERING LEVER IS IN THE RIGHT POSITION: The lever is found on the motor unit and must be positioned on the symbol (P) in the case of installation in ducting version (Fig. also remember that the use of charcoal filters is not necessary with the ducting version; if these are fitted, remove them and proceed as following according to the model type purchased: - if the hood features round charcoal filters (Fig. 14R), remove the charcoal filter by turning it clockwise. - if the hood features a panel type charcoal filter (Fig. 15A), remove the charcoal filter by first of all removing the two filter retainers M (the two filter retainers must then be fitted back on). INSTALLATION IN FILTERING VERSION: Prepare a suitable power supply. For the electrical connection, follow all the other instructions on the "Warnings" sheet. The 2 openings (A and B) on the hood (Fig. 5) must not be closed, since the air is recirculated into the room through the front vents. Proceed with fixing the hood: Based on your requirements, you can fit the hood on the wall or on a wall unit of your kitchen. IMPORTANT: Respect the distance between the hob and lower part of the hood which must be at least 650 cm. Fixing to the wall: Before fixing the hood to the wall, check the position of the power outlet and consider where the power cable will run, since a hole might have to be made in the wall unit to accommodate it. Draw a line on the wall in vertical line with your hob. Mark the 4 holes to be drilled in the wall, respecting the distances indicated in Fig. 9; Make the 4 holes and fit the 4 screw anchors provided. 10G) and insert them in the topmost screw anchors without however screwing them down completely. Hang the hood on the 2 screws; Working from inside the hood, tighten the 2 screws completely. Now proceed with final fixing by fitting the other 2 screws H (Fig. Fitting under wall unit: Before fixing the hood to the wall unit, check the position of the power outlet and consider where the power cable will run, since a hole might have to be made in the wall unit to accommodate it. Drill 4 holes in the wall unit, respecting the distances indicated in Fig. Push the hood up against the wall unit and insert the 4 screws operating from inside the wall unit (the 4 screws are not provided). We recommend you: CHECK THAT THE DUCTING-FILTERING LEVER IS IN THE RIGHT POSITION: The lever is found on the motor unit and must be positioned on the symbol (Q) in the case of installation in filtering version (Fig. [. . . ] To remove the charcoal filters, proceed as follows, depending on the model purchased: - if the hood features round charcoal filters (Fig. 14R), remove the charcoal filter by turning clockwise. - if the hood features a panel type charcoal filter (Fig. 15A), remove the carbon filter by first of all removing the two filter retainers M. [. . . ]