User manual ZANUSSI ZI1643

[. . . ] KHLSCHRANK REFRIGERATEUR KOELKAST REFRIGERATOR ZI 1643 ZI 2443 D F BEDIENUNGSANLEITUNG GEBRUIKSAANWIJZING 2222750-24 MODE D'EMPLOI INSTRUCTION BOOKLET Instructions for the use of the instructions booklet Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance Safety Instructions This information has been provided in the interests of your safety. Please read it before installing or using the appliance. Please retain the instruction book for future reference. [. . . ] The defrost water drains out through a trough into a container at the back of the appliance, above the motor compressor, where it evaporates. D037 It is important to periodically clean the defrost water drain hole. 39 Freezer compartment Remove the frost with a plastic scraper. Whenever the thickness of the frost exceeds 5 mm complete defrosting should be carried out. Prooceed as follows: Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. Pull out the plug from the wall socket or turn the thermostat knob to the O setting. Leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure. Cleaning Never use metal objects for cleaning your appliance as it may get damaged. Turn the temperature regulator to a warmer setting temporarily. Turn the thermostat knob to a lower number. The temperature where the cabinet is placed is above normal room temperature. Check that the ventilation is sufficient and that the ventilation openings are unobstructed. The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door. During automatic defrosting frost thaws on the cooling plate. Place the drain hose at the back of the cabinet above the drain bowl. Temperature control may cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. The motor may cause a humming noise and/or slight bumping. The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption. It is too warm inside the refrigerator It is too cold inside the refrigerator. The compressor works continuously. There is water inside/outside the refrigerator. Noises Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: Model Name Model Number (PNC) Serial Number (S-No. ) This information can be found on the rating plate inside the cabenit on the left hand wall. We recommend that you enter this information here, so that it is handy if needed. Technical specifications The technical data is indicated in the rating plate on the left side inside the appliance. If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. [. . . ] So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. [. . . ]