User manual ZANUSSI ZI428D

[. . . ] REFRIGERADOR CONGELADOR FRIDGE-FREEZER ZI 428 D LIBRO DE INSTRUCCIONES 2222 126-83 INSTRUCTION BOOKLET MANUTENCION Siempre desenchufe el aparato antes de efectuar cualquier operación. Lavar el interior periódicamente con agua tibia y bicarbonato sódico, limpiar el mueble con un spray de cera a la silicona, limpiar el condensador y el motocompresor con un cepillo o aspirador. Durante los períodos en los cuales el aparato no esté funcionando observar las siguientes precauciones: Desenchufarlo. Limpiar el interior y todos los accesorios. [. . . ] This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Location Place the appliance as far away as possible from sources of heat, e. g. radiators, heaters, direct sunlight, etc. The best results are achieved with a room temperature ranging from +16°C to +32°C (class N) or from +18°C to +38°C (class ST). The class of your appliance is shown on its rating plate. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly. Do not use detergents or abrasive powders as these will damage the finish. Power connection Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. For operation using different voltages you should use an autotransformer of suitable capacity. The appliance's plug and the wall socket are fully compatible, without any need to use adaptors, multiple plugs, etc. If this is not the case, the wall socket should be replaced to make it compatible. The appliance MUST be connected to an efficient earth or ground tap. The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. 1 A Instructions for total built-in Door reversibility Right-hand opening Remove the pins (A) and (B). Left-hand opening Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Housing's dimensions Height 1580 mm Depth 550 mm Width 560 mm 1 C 2 3 B D501 D 13 For appropriate venting, follow indications in Fig. 2 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. cm2 200 D D033 Push appliance into housing until stop strip (A) touches the kitchen unit. [. . . ] 14) into a special container on the back of the appliance, where it evaporates. 11 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D037 D040 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required (Fig. 12 The freezer compartment, however, will become progressively covered with frost. [. . . ]