User manual ZANUSSI ZI5235

[. . . ] This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 50 mm Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. min. 2 Push appliance into the housing until stop strip (A) touches the kitchen unit. D022 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 14 Fig. 3 Open the door and push the appliance against the side of the kitchen unit opposite to that of D appliance hinges. Fasten the appliance with 4 C screws provided D615 in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. 4 Press in the joint covers between the appliance and the kitchen unit. 8mm PR34 Fig. 7 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. D616 Fig. [. . . ] To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required (Fig. 13 The filter is held by two small support frames which press into position and are therefore easily removed for cleaning. To do this, turn the glass shelf upside D003 down and release the frames as shown in the illustration. The filter may be washed in normal washing-up liquids. [. . . ]