User manual ZANUSSI ZI9454X

[. . . ] FRIDGE-FREEZER ZI 9454 X © Electrolux plc 2004 INSTRUCTION BOOKLET 2222 214-73 IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety. You MUST read it carefully before installing or using the appliance. Installation · · · This appliance is heavy. [. . . ] The wheels are factory set for a work top height of 820 mm. To align the appliance to work top height of 870 mm, raise it by adjusting the feet with a spanner, then remove the wheels and refit them in the lowest position. 820 J. Button ON/OFF ON: Press the button (K). the door has been left open for a long time warm food has been placed in the compartment O. Super Cooling button The maximum performance is obtained by setting the Super Cooling function. It's recommended when loading large quantities of food. Press the Super Cooling button (P). The relevant pilot light (O) illuminates. The internal temperature goes down to +2°C. After about 6 hours the Super Cooling function switches off automatically. 870 OFF: Keep the button (K) pressed until the pilot light (J) and the temperature indicator switches off. L - N. Temperature setting buttons The temperature can be adjusted between +2°C and +8°C. By pressing the button (L or N), the current temperature setting flashes in the indicator panel. It is only possible to modify the setting temperature only with the indicator flashing. To set a warmer temperature, press button (L). To set a colder temperature, press button (N). The indicator panel displays the newly selected temperature for a few seconds and then shows again the internal compartment temperature. The newly selected-temperature should be reached after 24 hours. During the initial stabilising period the temperature displayed cannot correspond to the requested temperature. During this time it is possible that the temperature displayed is lower than the actual temperature. REAR EDGE RIGHT HAND SIDE PANEL FRONT EDGE Fitting the side panels · Fit the brackets onto the panels in the positions shown in the diagram. The dimension of 132 mm is allowed for fitting a 100 mm plinth below the panel. For different plinth sizes, reduce or increase the dimension of 132 mm accordingly. 15 820 15 280 INSIDE FACE 1052 275 5765 Q. Dynamic Air Cooling button Push the D. A. C. · · Rest the panels against the appliance. [. . . ] In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. 14 11 SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:- Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. [. . . ]