User manual ZANUSSI ZJ1284

[. . . ] WASHING MACHINE ZJ 1284 PROGRAMMES ON-OFF 650 rpm QUICK WASH RINSE HOLD PLUS RINSE SENSOR INJECTION ZJ 1284 124973320 INSTRUCTION BOOKLET Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation l Use l This appliance is heavy. [. . . ] Unscrew and remove the filter. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. After each wash Leave the door open for a while. This helps to prevent mould and stagnant smells forming inside the appliance. Keeping the door open after a wash will also help to preserve the door seal. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. P0037 Cleaning the dispenser drawer From time to time the washing powder and additive dispenser drawer should be cleaned. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. P0039 Clean carefully under a fast running tap. P0040 P0010 P0009 Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. Warning When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. P0038 15 The water inlet filters If your water is very hard or contains traces of lime deposit, the water inlet filters may become clogged. It is therefore a good idea to clean them from time to time. Remove and clean the filters using a hard bristle brush. Replace the filters and tighten up the inlet hoses. P0041 The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. l l l Turn off the water taps. Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hoses in a bowl. Screw the inlet hoses and reposition the drain hose. When you intend to start the machine up again, make sure that the room temperature is above 0°C. l l l 16 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom The machine does not start Possible causes l l l l l l The door has not been closed. The plug is not properly inserted in the power socket. There is no current at the socket The main fuse or the fuse in the plug has blown. The selector dial is not correctly positioned. [. . . ] B), adjust the door and tighten the screw again. d) Counter-magnet (6) The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D). 195 6 165 160 4 1 1 2 7 5 6 3 4 23 P0982 8 B a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. [. . . ]