User manual ZANUSSI ZK23/11R00

[. . . ] m Make sure that the cable is not trapped underneath the appliance, nor touches the motor. m Repairs carried out by inexperienced persons may cause injuries or serious malfunctioning. m Make sure the rear part of the appliance stands against a wall as there are working parts which heat up and should not be of easy access. m Make sure that there is a continous and adequate ventilation as a failure to do so may result in damage to the appliance or deterioration of the food. [. . . ] Press: the upper button "+" to set a higher temperature, or disconnect the freezer part (OF appears in the display) the lower button "­" to set lower temperature. Keep pressing until the desired temperature flashes in the display. Press the alarm shut-off button to switch off the audible alarm. The temperature display will stop flashing. The red warning lamp goes out when the temperature inside the freezer again falls below - 11°C. See the chapter «If the Fridge/Freezer does not perform correctly». Temperature display (g) Shows temperatures between + 39°C y - 39°C. The temperature display starts flashing when the freezer temperature is set. The temperature varies in different parts of the freezer. The display shows the temperature in the warmest product in the freezer. If the temperature is measured using a standard single thermometer, place it among the stored products. Do not place the thermometer hanging or lying directly on the freezer shelf. SUPERFROST (e) Press this button 24 hours prior to putting in food products. The yellow lamp «e» will go out. 37 Setting the temperature The recommended temperature ­ for the refrigerator is +4°C / +6°C ­ for the freezer is -18°C / -20°C Use the temperature adjustment buttons «b» (refrigerator) and «f» (freezer) to set the temperature. Press «+» to set a higher temperature. Press «-» to set a lower temperature. Keep pressing until the desired temperature is shown in the temperature display. The freezer temperature display shows the current temperature inside the cabinet. The refrigerator temperature display shows «OF» until the temperature inside the cabinet reaches + 9°C. Switching off To switch off the entire cabinet Press the power switch «a» on the panel to switch off the cabinet. To avoid accidentally switching off the appliance, the power switch must be kept pressed for about 1 second. Disconnect the power plug from AC outlet. To switch off only the refrigerator or freezer Switch off the refrigerator or freezer using b «+» for the fridge or f «+» for the freezer until «OF» appears in the display. How to use your Refrigerator-Freezer Keeping frozen food For optimum consevation, the temperature inside the freezer compartment must be at least -18°C. This temperature is adjusted automatically. [. . . ] · Change the temperature regulator to an adequate position or switch off the Dinamic Refrigeration. · Wait for the appliance to come back to normal. 4. The motor does not stop running: C) WATER/ICE 1. · Wrong temperature setting · Door not properly closed. [. . . ]