User manual ZANUSSI ZOU885ALU

[. . . ] Electric Built-in Oven «ÎÂÍÙÒÈÍ¸Ú ^ÔÒÌÔÚ ZOU 885 ALU Instruction booklet oeÁ, , flÂÚ ~ÒfiÛÂÚ ENGLISH Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation · It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. It is dangerous to alter the specification in any way. Once you removed all packaging from the appliance, ensure that it is not damaged and the electric cable is in perfect conditions. [. . . ] Neither oven functions nor temperatures can be selected. To unlock the oven: Press buttons and " " at the same time and keep them pressed for about 3 seconds. The Electronic Control beeps once and the message `SAFE' goes off. 19 "Fast Heat Up" function (Booster) After a cooking function has been selected and the temperature has been adjusted, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on selected function and temperature. If it is necessary to reach the required temperature in a shorter time, the fast heat up function can be used. Switch the oven on by pressing the "On/Off" button . Set the required cooking function and temperature as described in the previous pages. Set the temperature by pressing button " " or " ". Press the "Fast Heat Up Function" button temperature display shows "FHU" (Fig. If you press the "Cooking Function" button , the temperature display reverts to the selected temperature and symbol " " flashes for 5 seconds (Fig. 21). During this intervel, you can adjust the temperature setting by pressing button " " or " ". When the required temperature is reached, the Electronic Control beeps for a short time, and the temperature display reverts to the selected temperature. This function can be used with any cooking function or temperature. Fig. 21 11 Residual Heat Function When a Cooking Duration time is set, the heating elements of the oven will automatically go off a few minutes before the end of the programmed time, and the oven will use the residual heat to finish your dishes without energy consumption. All current settings will be displayed until the Cooking Duration time is over. This function will not operate when the Cooking Duration time is less than 15 minutes. "Demo" mode This mode is intended to be used in the shops to demonstrate the oven functionality without any power consumption except the oven lamp. To activate this function the appliance should be off. Press button and " " at the same time for approximately 2 seconds (Fig. When you press button to switch on the oven, the message "DEMO" appears on the upper section of the display (Fig. 23). You can then select any cooking function, but the oven will not heat up. The thermometer symbol will come on , but it will not flash nor rise. Fig. [. . . ] Check that the main fuse and the domestic installation can support the load; 2. Check that the power supply is properly earthed in compliance with the current rules; 3. Check the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. This appliance is delivered without an electric supply cable. [. . . ]