User manual ZANUSSI ZOU893QX

[. . . ] Einbau-Herd Built-under oven ZOU 893 Q Bedienungs- und Einbauanweisungen Instruction booklet English Warnings - Built-under oven It is most important that the instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. Installation Any installation work must be undertaken by a qualified electrician or competent person. [. . . ] The programmer will beep and the pilot lamp will go out. "Cooking duration" and "End of combined cooking time" The functions "Cooking duration" e "End of cooking time" can be used simultaneously to set the oven to switch on and off automatically at a later time. With the "Cooking duration" function (carry out the cooking duration setting as described in the relevant chapter) set the duration time. Then, press button : the display will show the programmed setting. With the "End of cooking time" function the End of cooking setting as described in the relevant chapter) set the end of cooking time. The relevant pilot lamps will come on and the display will show the time of day. The oven will switch on and off according to the set programmes. "Minute minder" function The minute minder alarm will sound at the end of a timed period, but THE OVEN WILL REMAIN ON, if it is in use. Press button repeatedly to select the "Minute minder" function. The relevant pilot lamp will start flashing. Then, press button " " or " " (maximum: 2 hours, 30 minutes). After the setting is carried out, wait for 5 seconds: the "Minute minder" pilot lamp will come on. If cooking requires more heat from the top or from the bottom use the top or the bottom runners. Thermal grilling When using this function, select a maximum temperature of 200 °C. The full grill element and the oven fan operate alternately, circulating hot air around the food. The need to check and turn food is reduced. With the exception of toast and rare steaks, you can thermal grill all the foods you would normally cook under a conventional grill. Fan cooking Fan cooking The food is cooked by means of preheated air force blown evenly round the inside of the oven by a fan set on the rear wall of the oven itself. Heat thus reaches all parts of the oven evenly and fast and this means that you can simultaneously cook different types of foods positioned on the various oven shelves (Fig. Fan cooking ensures rapid elimination of moisture and the dryer oven environment stops the different aromas and flavours from being transmitted from one food to another. The possibility of cooking on several shelf heights means that you can cook several different dishes at the same time and up to Fig. 5 FO 0351 32 Some hints For baking cakes Cakes require a moderate temperature (normally between 150 and 200 °C). In addition, the oven must be heated up beforehand - for about 10 minutes. The oven door should not be opened before at least 3/4 of the set cooking time is up. Normal short pastry dough should be cooked in a mould or tin for 2/3 of total cooking time required and then garnished as desired before being cooked completely. [. . . ] After connecting the supply cable to the terminal board, secure it with a junction clamp. Electrical connection Prior to making the electrical connection, make sure that: -- the protection fuse and the domestic wiring system are suitable to carry the total electric load of the oven (see rating plate); -- your domestic wiring system has an efficient earth connection in compliance with rules and laws in force; -- the wall socket or the omnipole switch used for the electrical connection can easily be reached after the oven is built in. This appliance is delivered without an electric supply cable, therefore, you will have to fit to it a supply cable with standard plug, suitable for the total electric load shown on the rating plate. The plug is to be inserted into a suitable wall socket. If you require a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, with a minimum gap between contacts of 3 mm, suitable for the required load and in compliance with rules in force. [. . . ]