User manual ZANUSSI ZR220/2TF

[. . . ] FRIGORIFEROCONGELATORE FRIDGE-FREEZER KÜHLGEFRIERSCHRANK ZR 220/2T F LIBRETTO ISTRUZIONI 2222 255-03 INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . page 11 12 12 12 12 12 12 15 15 15 15 15 15 16 16 16 16 17 18 18 18 18 18 Installation . page Storage of frozen food Thawing . page 10 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. [. . . ] Refit the door and pin (A) on the left side. Remove pin (D) from the right side. Housing dimensions Height Depth Width 1225 mm 550 mm 560 mm For appropriate venting, follow indications in Fig. 5 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance D hinges. Fasten the appliance with 4 C D032 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. 6 Press in the joint covers between the appliance and the kitchen unit. min. 3 Push appliance into the housing until stop strip (A) touches the kitchen unit. D030 D015 Fig. 4 If after having carried out the previously A described operation there is still some space left between the appliance and the kitchen unit, fit the trimming D265 provided together with the appliance on the stop strip (A). Fig. 7 Apply covers (B) on joint cover lugs and into hinge holes. B D013 13 Fig. 8 Position the runners (H) at the H top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the 20m m position of the external holes. After preparing D094 the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. 9 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. 8mm PR34 Fig. 10 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). PR35 For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 14 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. 11 Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. [. . . ] 14 Place a basin on the first grill shelf in the refrigerator directly below the drainage hole and lift up the small lid (Fig. 15 D016 D037 Clean periodically the water discharge hole in the centre of the drip collector. Use the special cleaner provided, which you will find already inserted into the discharge hole (Fig. The freezer compartment, however, will become progressively covered with frost. [. . . ]