User manual ZANUSSI ZR220/2TN

[. . . ] FRIGORIFEROCONGELATORE FRIDGE-FREEZER KÜHLGEFRIERSCHRANK REFRIGERATEURCONGELATEUR ZR 220/2TN LIBRETTO ISTRUZIONI 2222 255-05/2 INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D'EMPLOI WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. General Safety This appliance is designed to be operated by adults. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D Fig. 5 D032 C 17 Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D030 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 B D013 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 18 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 The doors can be opened using the sliding system previously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. Fig. 10a D029 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB 19 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer. [. . . ] Use the special cleaner provided, which you will find already inserted into the discharge hole (Fig. The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]