User manual ZANUSSI ZRB2825W

[. . . ] REFRIGERATORFREEZER ZRB 2825 W USER MANUAL 2223 265-41 IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety. You MUST read it carefully before installing or using the appliance. Installation · · · This appliance is heavy. [. . . ] For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. You MUST ensure that the appliance is switched OFF Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. D411 Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with one of the same power (the maximum power is shown on the light diffuser) available from your nearest Service Force Centre. Replace the light cover by sliding it into its original position and replacing the screw. Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. PR259 D037 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the fruit and vegetable drawer. Use the defrost cleaner provided which you will find already inserted into the discharge hole. Remember to wash the defrost cleaner in hot soapy water at regular intervals. Dry throughly before replacing. 8 Freezer When the frost has reached a thickness of up to 4mm it can be removed using the ice scraper provided with the appliance. During this operation it is not necessary to disconnect the appliance from the mains and remove the food. Never use metal tools for this operation. For complete defrosting (once or twice a year) proceed as follows: turn the thermostat dial to the «OFF» position (O) or disconnect the appliance from the mains. Remove any food from inside the freezer and fridge, wrap it in several sheets of newspaper and store in a cool, dry place. Leave the door open and insert the ice scraper under the channel in the centre of the lower part of the appliance; place a low-sided container beneath the scraper to collect the water (see fig. ). Replace the scraper in one of the drawers . Reconnect the appliance to the mains or reset the thermostat to a functioning position. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. D068 - - Important When defrosting the freezer, the fridge is also controlled by the thermostat and will not be operational during this period. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Attention! In the event of a power failure causing the temperature within your freezer to rise, do not refreeze the food without checking its condition. The following guidelines should assist you. Ice-cream: once thawed should be discarded. Fruits & Vegetables: if soft should be cooked and used up. Breads & Cakes: can be re-frozen without danger. [. . . ] Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Blue Brown - Earth - Neutral - Live The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. [. . . ]