User manual ZANUSSI ZRD 23 JC

[. . . ] ZANUSSI KÜHL - GEFRIERKOMBINATION RÉFRIGÉRATEUR CONGÉLATEUR FRIGORIFERO-CONGELATORE COMBINATO REFRIGERATOR- FREEZER COMBINATION ZRD 23 JC GEBRAUCHSANLEITUNG MODE D`EMPLOI LIBRETTO D'ISTRUZIONI INSTRUCTION BOOK DE FR IT GB 200369262 SV/Za/9. (05. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. [. . . ] during heatwaves, the refrigerator temporarily happens to operate constantly. During this the automatic defrosting is ineffective. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The pipe scraper has to be stored in the outlet. 46 Remaining small ice and frost stains on back plate of the refrigerator after defrosting period is not abnormal. The freezer can not be equipped with automatic defrosting set since the deep-frozen and frozen foods do not endure melting temperature. When small frost and ice occurs scrape off and remove frost and ice coating with the supplied plastic scraper. The tray in figure is not a piece of accessories to the appliance!When ice coating is so thick that it cannot be removed with the plastic scraper, the cooling plate has to be defrosted. Frequency of defrosting depends on usage (generally 2-3 times a year). Take the frozen foods out of the appliance, and put them into a basket lined with paper or cloth. Store them in a possibly cool place or replace them into another refrigerator. Pull out the mains plug from the mains socket, so both parts of the appliance are out of operation. Open the doors of both parts of the appliance and clean the refrigerator according to 'Regular cleaning'. Maintain and clean the freezer as following: Sweep the melting water with a cloth or sponge off the cooling plate. The melting water swept down gathers in the bottom of the appliance and can be removed with a hygroscopic cloth or a sponge. Wipe the surfaces after defrosting. GB Put the mains plug into the mains socket and put foods taken out back to their places. It is recommended to operate the appliance at the highest position of the thermostatic control for some hours so that it can reach the sufficient storing temperature as soon as possible. Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time using lukewarm water then wipe it (it is practical to clean the inside of the freezer and defrost it at a time). Household cleaner or soap must not be used. After breaking the circuit wash the appliance with lukewarm water then wipe it. After cleaning apply voltage to the appliance. It is recommended to remove the dust and dirt collected on the back of the refrigerator and the condenser and to clean the evaporative tray on top of the compressor once or twice a year. When the refrigerator is not in use In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Leave the door open to avoid a build up of air inside. Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. [. . . ] The data label of the appliance is stuck to the wall of the interior beside the vegetable box in the fresh food compartment in the bottom on the left side. All necessary data are there which are needed to the service announcement (type, model, serial number, etc. ). Note here the data from the data label of your appliance: Model Product No. Date of purchase: The manufacturer reserves the right to make any changes in the products. 53 54 SV/Za/9. [. . . ]