User manual ZANUSSI ZSF 2440S

[. . . ] D I S H WA S H E R ZSF 2440 156 989 310 Contents For the user Safety Information Description of the appliance - Spray arm - Coarse strainer/microfilter - Fine filter - Detergent dispenser - Rinse aid dispenser - Water softener For the Installer 3 4-5 Technical Specifications Unpacking - Damages - Use - Positioning 15 16 Installation 6 7 8 9 10 - Water inlet - Water drainage - Power supply 17-18 The control panel - How to set the delayed start Information for test centres 19 Adjusting the water softener Programme chart Loading and unloading Using the appliance - Starting the programme - Interrupting the programme temporarily - Cancelling the programme - Pause function - Cancelling the drying phase - Switching the dishwasher off Maintenance and cleaning Something Not Working Service - Service and Spare Parts - Customer Care Department 11 12-13 13 Guarantee Conditions 14 Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety information Step by step instructions Hints and tips Environmental information -2- Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. Installation and servicing G G All installation work should be done by a qualified or competent person. Any servicing must be carried by a qualified and authorised engineer. [. . . ] Substances such as ketchup containing strong colouring agents can cause temporary discolouration to the interior of the dishwasher. Do not place sharp knives with their points upwards. It is much safer to lay them horizontally in the main basket. G G G Unloading Hot dishes are sensitive to knocks. Always let the dishes cool down before unloading. The dishes dry faster if the door is opened slightly for a short time once the programme has finished. Use care when opening the door as hot steam may escape. -9- Using the appliance Starting the programme 1. Scrape or rinse off solid food remnants. Put the correct amount of detergent into the detergent dispenser and close the lid. Press in the required programme button (see programme chart). All other programme indicator lamps go out. The lamp always indicates which part of the selected cycle the dishwasher is in. Check the filters to see if they need to be cleaned when the dishwasher has finished the programme. Pause function With the pause function the programme can be temporarily interrupted for a short period of time. When you want the programme to continue again, press the On/Off button once more. The programme should not be paused for any longer then necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption. Cancelling the drying phase In case you do not want to wait until the drying phase is completed, you can cancel it. The drying phase is cancelled. Interrupting the programme temporarily 1. Close the door and the programme continues after about six seconds. Open the door carefully when the dishwasher is running, since hot steam may escape. Switching the dishwasher off Switch the dishwasher off when the lamp for the completed programme cycle is lit or the display shows 0. Press in the On/Off button. Cancelling the programme 1. Press and hold in the combination buttons, the machine goes to starting position and all programme indicator lamps are lit. The programme is now cancelled and a new programme can be selected. If you switch the dishwasher off with the On/Off button, the selected programme is not finished, it is only disrupted. When you start the dishwasher again, the programme will continue. 2. [. . . ] In the event of a fault the drain-pump starts automatically and the remaining water inside the dishwasher is pumped out. The water safety system also works when the dishwasher is switched off. However the dishwasher must be connected electrically. Place the discharge hose over the sink as illustrated. [. . . ]