User manual ZANUSSI ZSF6150S

[. . . ] DISHWASHER ZSF 6150 ZSF 6150 S 152963 08/1 Instruction Book UK Contents Safety instructions Disposal Economical and ecological dishwashing Description of the appliance The control panel Prior to using for the first time The water softener Filling with dishwasher salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine What to do, when. . . Service and Spare Parts Customer Care Department Guarantee Conditions 3 3 3 4 4 6 6 7 8 9 9 9 10 10 10 11 12 13 14 15 15 15 15 15 16 18 18 19 Installation instructions Fitting under a counter Levelling Water supply connections Water outlet hose connection Electrical connection Hints for test centres 20 20 20 20 21 21 22 Technical specifications Dimensions Width Height with worktop Height without worktop Max depth Max depth with open door 60 cm 85 cm 82 cm 63. 5 cm 118. 5 cm Electrical connection: Voltage Overall power Fuse Water supply pressure Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher's door. Minimum Maximum 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 2 Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. [. . . ] Partial load (to be completed later in the day). Rinse Hold 12 0, 1 4 (1) Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil). This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. Testing programme for EN 50242 (see "Hints for Test Centres"). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of washing and drying have been extended. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. (2) (3) "Automatic" washing programme During the "Automatic" washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for Automatic programme (see "Washing programmes chart"). During the "Automatic" programme the temperature of the main wash water is also automatically adjusted between 50°C and 65°C depending on the amount of soil on the dishes. 13 Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Press the On/Off button The On/Off indicator light will come on (setting mode). 6. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. To interrupt a washing programme in progress a) Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. b) Press the On/Off button (in this case all the indicator lights turn off). Press the On/Off button again; the programme will start from the point at which it was interrupted. 5. Setting and starting the programme Press the button corresponding to the required programme (see "Washing programmes" chart). The indicator light corresponding to the programme and the phase indicator lights foreseen for that programme will start blinking. After about 3 seconds from the last pressure of a button the programme starts automatically. Once the programme has started the phase indicator lights will turn off except for the phase under way. To cancel a washing programme in progress To cancel a washing programme in progress, press simultaneously the function buttons 2 and 3 until all the indicator lights will turn off (except for the On/Off indicator light and eventually the rinse aid and salt indicator lights) indicating that the running programme has been cancelled. [. . . ] The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Electrical connection This appliance must be earthed. [. . . ]