User manual ZANUSSI ZTE240

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] Press the button as many times as necessary until the required programme running time is shown in the display Select the "Start/Pauze" Press this button to start the dryer after having which lasts around 90 minutes. Select the "Tijd" This option can be used for WOOL selected the programme and the options. The relevant light will stop flashing. If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound and the programme phase indicator lights will flash. The drum turns alternately in both directions during drying. All drying programmes end with a 10 minute cooling phase (light Cooling is on). You may remove the laundry after this phase. The display will show the symbol Long Anticrease, and lights "Filter" and "Waterhouder" illuminate and the buzzer sounds If the door of the appliance or the small door at the bottom is opened while the programme is running, this button must be 15 pressed again after closing the door in order to restart the programme from the point at which it was interrupted. This button must be depressed also after a power failure and after having reinserted the water reservoir, if it has been emptied in the middle of a programme after lighting up of light "Waterhouder". In both cases the light of the "Start/Pauze" button flashes to remind you that the start button needs to be pressed again. Select the "Startuitstel" With the "Startuitstel" button, you can 16 delay the start of a programme by between 30 minutes (30' and a maximum of 20 hours (20H). Lights FILTER and WATERHOUDER remain lit and the buzzer sounds for 2 minutes. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Turn the programme selector dial to "O" to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you open and then close the door before turning the selector dial to "O" all the lights corresponding to the phases making up the performed programme come on. After each use ·Clean the filters. If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position Cooling "LUCHTEN" and wait until the end of this cooling phase before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn the 17 dial to "Off" and then to Cooling "LUCHTEN" and depress Start button. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to "O". Select the new programme and press the Start button . [. . . ] Do not restrict the floor clearance through deep-pile carpets, strips of wood or similar. This might cause heat build-up which would interfere with the operation of the appliance. Important The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures. [. . . ]