User manual ZANUSSI ZUD5155

[. . . ] Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. This appliance is designed to be operated by adults. [. . . ] Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 42 820 Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 2 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 2). 820-870 600 547 550 59 6 D506 100-170 870 Location Fig. 2 Door reversibility Remove the two screws which fix the upper hinge to the door. 3 Carefully lean the appliance on its back and remove the plastic insert (Fig. Remove the two screws which fix the lower hinge to the door. Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself. 4 Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4) and using the screws removed from the lower part, fix it to the base of the appliance itself. 12 If the appliance has been fitted into a space 820 mm high and the maximum height of the base plate is 100 mm, fit the front cover plate by pushing the two vertical lugs into the rectangular holes on the bottom side of the ventilation duct until they click. The plate can be adjusted backwards or forwards in the holes (Fig. 12 170 220 600 135 185 D518 Fig. 13 If the base plate is between 100 and 135 mm high, cut it as shown in Fig. If the base plate is between 135 and 170 mm high, cut it as shown in Fig. 13 2 0 0÷8 100 150 D546 min. 14 If the appliance has been fitted into a space 870 mm high and the maximum height of the base plate is 150 mm, fit the front cover plate as described in Fig. If the base plate is between 150 and 185 mm high, cut it as shown in Fig. If the base plate is between 185 and 220 mm high, cut it as shown in Fig. 12. D520 820 870 100÷135 150÷185 45 Changing the opening direction of the door Having changed the opening direction of the appliance door, it is advisable to also change the opening direction of the freezer compartment door. 15 Unscrew the two fixing screws to remove the lower hinge from the door (Fig. [. . . ] Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. For better use of space, the front half-shelves can lie over the rear ones. Storage of frozen food To obtain the best performance from this appliance, we strongly recommend that you make sure that the commercially frozen foodstuffs were adequately stored by the retailer and, furthermore, be sure that these frozen foodstuffs are transferred from the foodstore to the consumer in the shortest possible time (a temperature increase of the frozen food could shorten its storage period). [. . . ]