User manual ZANUSSI ZUD7120

[. . . ] GEFRIERSCHRANK CONGELATEUR KOELKAST FREEZER ZUD 7120 BEDIENUNGSANLEITUNG MODE D'EMPLOI GEBRUIKSAANWIJZING INSTRUCTION BOOKLET 2222 258-12 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. s General Safety s This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 36 820 Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 2 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 2). 820-870 600 547 550 59 6 D506 100-170 870 Location Fig. 2 Door reversibility Remove the two screws which fix the upper hinge to the door. 3 Carefully lean the appliance on its back and remove the plastic insert (Fig. Remove the two screws which fix the lower hinge to the door. Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself. 4 Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4) and using the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side. 5 Place the appliance in the position where it is to be built in (Fig. 5) The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. Keeping the appliance central in the recess, slide it in until its back touches the wall. With a tape measure (or similar instrument), measure distance (A) between the top edge of the door and the top edge of the decorative panel, placing it next to the recess. D507 Fig. 5 A = = D467 37 Fitting a decorative door panel Important :The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3. 5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins prefitted on the appliance door. [. . . ] On the rear of the door you will find a list of foods followed by a number. These numbers indicate the maximum period of time for which the food in question may be conserved (in months). Do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter. Important Do not put carbonated liquids (fizzy drinks, etc. ) in the freezing compartment as they may burst. [. . . ]