User manual ZANUSSI ZUD7155

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ] For building into kitchen units follow the special " Building-in" instructions given. Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. . This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 36 820 Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 2 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 2). 820-870 600 547 550 59 6 D506 100-170 870 Location Fig. 2 Door reversibility Remove the two screws which fix the upper hinge to the door. 3 Carefully lean the appliance on its back and remove the plastic insert (Fig. Remove the two screws which fix the lower hinge to the door. Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself. 4 Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4) and using the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side. 5 Place the appliance in the position where it is to be built in (Fig. 5) The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. [. . . ] It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use a flexible rod to clean the drain hole. Fig. 18 41 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: s s Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorized technicians. unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. Internal cleaning Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. Fig 19 External cleaning Wash the outer body with lukewarm water and soap. [. . . ]