User manual ZANUSSI ZV120RM

[. . . ] After dissolving frozen food must not be refrozen, it must be used up as soon as possible. Store pre-packed frozen food in accordance with the frozen food manufacturer's instructions. You must not make defrosting faster with any electric heating appliance or chemicals. Do not put hot pot to the plastic parts of the freezer. [. . . ] The thermostat can be switched off (STOP position), which means breaking the circuit of the compressor i. e. The temperature coming about in the freezer is effected by not only the position of the thermostatic control and the ambient temperature, but frequency of door openings and the quantity of food put into it, etc. In maximum position of the thermostat - in case of increased demand e. g. during heatwaves the compressor may operate continually. This does not cause damages to the appliance. Freezing Freezing different products should always be done in the freezing compartment after proper preparing. Set the thermostatic control knob to SUPER position 4 hours before freezing food in small quantity and about 24 hours before in case of products in bigger quantity. This time the compressor operates continually to reach temperature necessary for freezing. Place the foods to be frozen in and operate the appliance as written for about 24 hours. After these reset the thermostatic control knob to NORMAL position. 18 GB Storing It is practical to replace frozen products into the storing compartment after freezing has finished so that to make room in the freezing compartment for another freezing. Intermediate freezing does not deteriorate foods already stored. Put warm foods into the appliance only when they are at room temperature. The condenser must be kept clean. The appliance and environment This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. Sweep off melting water, which gathers in the outlet channel practically formed in the bottom of the appliance, occasionally with a cloth or sponge in direction of sides. It can be removed if you put an adequately high tray in front of the appliance, which defrost water will flow into. Defrosting process can be made quicker by placing a pot or dish filled with warm water to the freezing shelf. Put the foods back. Regular cleaning It is practical to clean the inside of the freezer and defrost it at a time. Household cleaner or soap must not be used. After breaking the circuit wash the appliance using lukewarm water and wipe it. After cleaning apply voltage to the appliance. After each transportation the appliance must not be switched on for approx. Unpack the appliance and check if there are damages on it. Report possible damages immediately to the place you bought it. In that case retain packaging. Cleaning Remove every adhesive tape, which ensure the parts not to move in the appliance. [. . . ] Fix top door holder with 2 screws in the place set free being careful that the edge of the door is parallel with the side of cupboard. Put the covering of top door holder back. Put over the handle and the plastic nails on the other side. In case you do not want to perform the procedures above, call the nearest brand-mark service. Technicians will accomplish the refitting expertly for charge. 24 GB Electrical connection This refrigerator is designed to operate on a 230 V AC (~) 50 Hz supply. The plug must be put into a socket with protective contact. [. . . ]