User manual ZANUSSI ZV200S

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. Ice cube tray holder The holder is designed to hold the two ice cube trays supplied and it is recommended that these are used. The holder can be located onto the front of any of the baskets. D419 To make ice cubes: Fill the trays 3/4 full to allow the ice to expand and place in the ice cube tray holder. To turn out the ice cubes simply give the tray a slight twist to release the cubes. D755 16 Printed on recycled paper 5 Movable shelves The walls of the refrigerator have runners so that shelves can be positioned as desired. Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. D040 For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Service Force Centre. 87/308 of 2. 6. 87 relative to radio interference suppression. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. · · · · · B 10 mm It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e. g. not next to a boiler or radiator, or in a very cold room e. g. an outhouse, where the temperatures may fall below 10°C (50°F). colder or warmer, then the appliance may not operate correctly. You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4") distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B). There should also be a gap of 25 mm either side of the appliance. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation. Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a tool (see figure). · · · · NP00 In the Event of a Power Failure If there is a power failure during the storage of frozen foods, keep the door closed. [. . . ] Replace the scraper in one of the drawers . Reconnect the appliance to the mains or reset the thermostat to a functioning position. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. Important When defrosting the freezer, the fridge is also controlled by the thermostat and will not be operational during this period. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Before you move please contact your nearest Customer Care centre, listed below, to give them details of your new home. [. . . ]