User manual ZANUSSI ZVC47LE

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] Heating phase Temp. Spin Soil Level Easy Iron Extra Rinse 9 During the washing cycle the display shows a temperature icon animated to indicate that the appliance has started the heating phase of the The «Door Locked» icon appears on the display to indicate that the appliance starts operating and the door is locked. To interrupt a programme which is running, depress the «Start/Pause» button: the corresponding green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the «Start/Pause» button again. If you have chosen a delayed start, the machine will begin the countdown. 19 Operating sequence IMPORTANT!If an incorrect option is selected, the red pilot light of the «Start/ Pause» button flashes for 3 times and the message Err is displayed for few seconds. Select the Delay Start Delay Start Temp. Spin Soil Level Easy Iron Extra Rinse Cancelling the delayed start: You can cancel the delay time at any moment, before you press the «Start/Pause» button. If you have already pressed the Start/Pause button, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing the «Start/Pause» button; · press the Delay Start buttons once until the symbol «0'» is displayed. · press the «Start/Pause» button again to start the programme. The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing the «Start/Pause» button, wait until the «Door Locked» icon desappears. After you have closed the door, press the «Start/Pause» button again. At the end of the programme The machine stops automatically. Some acoustic signals sound for few minutes. The Start/Pause light goes off, the «Door Locked» icon desappears and on the display will appear a flashing «0. 00». If the «Rinse hold» or «Night Cycle» option has been selected, the display will show a flashing «0. 00» but the «Door Locked» icon remains visible. The door is locked to indicate that the water must be emptied out before opening the door. To empty out the water please read the steps on the «Night Cycle» option paragraph. Turn the programme selector dial to «Off» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 21 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. [. . . ] The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. Electrolux Service Force Centre must undertake all service work under this guarantee. Any appliance or defective part replaced shall become the Company's property. [. . . ]