User manual ZANUSSI ZWC7050W

[. . . ] User Manual Washing machine ZWC 6050 W ZWC 7050 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel - - - - - - - - - - - - - - - - - - - - - -6 Functions - - - - - - - - - - - - - - - - - - - - - - - - -7 Programme table - - - - - - - - - - - - - - - - - - -9 Programme information - - - - - - - - - - - - - -11 Washing Hints - - - - - - - - - - - - - - - - - - - - -12 Before the first use - - - - - - - - - - - - - - - - -14 Operating Sequence - - - - - - - - - - - - - - - -15 Care and cleaning - - - - - - - - - - - - - - - - - -18 What to do if. . . [. . . ] Press the button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 5. If the pilot light 7. 2 goes off, the door can be opened. If it does not switch off, this means that the machine is already heating, that the water level is above the bottom edge of the door. In this cases the door cannot be opened. If you cannot open the door but you need to 16 open it you have to switch the machine off by turning the selector dial to «O». After few minutes the door can be opened (Pay attention to the water level and temperature!). After closing the door, it is necessary to set the programme and the options again and then to press button 5. At the end of the programme The machine stops automatically, the pilot light of button 5, the pilot lights 7. 1 and 7. 2 go off and the pilot light 7. 3 goes on. If a programme or an option that ends with water still in the tub has been selected, the pilot light 7. 2 remains lit, the pilot light of button 5 goes off and the door remains locked to indicate that the water must be emptied out before opening the door. turn the programme selector dial to «O» 2. select the «Draining»or «Spinning» programme 3. reduce the spin speed, if needed, by means of the button 2 4. when the programme has finished the pilot light 7. 2 goes off and the door can be opened. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 17 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. [. . . ] Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. The appliance is supplied with a 13amp plug fitted. [. . . ]