User manual ZANUSSI ZWD1015

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] Display The display shows the following information: After selecting a programme the duration of the selected programme appears in minutes or hours and minutes on the display . (e. g. The delay time value decreases by one unit every hour, 90 minutes and then, when 1 hour remain, every minute. The incorrect option selection is indicated by the message Err displayed for few seconds and by flashing of the red light button 8. In the event of operating problems, some alarm codes can be displayed, (see paragraph "Something not working"). 2. 05) 2. 00 During the programme, the time remaining is updated every minute. E20 The End of programme or the stop wit water left in the tub is indicated by a flashing zero «0». Selected drying time After selecting a drying programme programme the drying time is shown in minutes or hours and minutes. After the programme has started, the time remaining is updated every minute. 0 Start the programme by pressing button 8 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. 17 1. 00 The Delayed start appears on the display for about 3 seconds, then the duration of the previously selected programme is displayed. IMPORTANT!If an option which is not compatible with the set wash programme is selected, the message Err is displayed for few seconds and the red light of this button flashes for 3 times. Altering an option or a running programme It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 8. Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by depressing button 8 again. Leave the door open to prevent the formation of mildew and unpleasant smells. 18 Drying only The max load to dry in your washer -dryer is 3 kg for cotton and 2 kg for synthetics. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. Turn the selector dial to «Cotton» or «Synthetics» programme in the «Drying» sector. For the automatic drying, «Store dry» or «Iron dry» (only for cottons), depress the button 3 until the light corresponding to the desired dryness degree for synthetics or cotton illuminates. For the timed drying, depress the button 4 until the time you want appears on the display (see the drying programmes). Press the button 8 to start the programme. At the end of the programme, the buzzer sounds. A flashing zero «0» will appear on the display. At this point, begins the anti-crease phase which lasts for about 10 minutes. During this time the light 9 is on and the door cannot be opened. If you whish to open the door before or during the anti-crease phase or to interrupt it, press any button or turn the programme selector dial to any programme position (except «O»), the door can be immediately opened. [. . . ] The switch must not break the yellow and green earth cable at any point. Fitting under a counter WARNING!Before any work to the appliance, you must disconnect the plug from the power socket. For safety reasons, it is dangerous to fit the appliance under a counter without the steel plate, which you can order in your nearest Service Force Centre. The top must be fixed to the cabinet as follows: Unscrew the screws from the back panel of the appliance. [. . . ]