User manual ZANUSSI ZWF12080W

[. . . ] User manual Washing Machine ZWF 12080 W ZWF 14080 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - - - -6 Programme table - - - - - - - - - - - - - - - - - - -9 Programme information - - - - - - - - - - - - - -11 Washing Hints - - - - - - - - - - - - - - - - - - - - -12 Before the first use - - - - - - - - - - - - - - - - -14 Operating Sequence - - - - - - - - - - - - - - - -14 Care and cleaning - - - - - - - - - - - - - - - - - -17 What to do if. . . [. . . ] Turn the programme selector dial to «Off» and then to the new programme position. Start the new programme by pressing the button 5 again. The washing water in the tub will not be emptied out. Interrupting a programme Press the button 5 to interrupt a programme which is running, the corresponding light starts to flash. Press this button again to restart the programme. Cancelling a programme Turn the selector dial to «Off» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 5 . The 6. 2 light flashes and after a few minutes, the door can be opened. If it remains lit, this means that the machine is already heating, that the water level is too high. In this case the door can not be opened. If you cannot open the door but you need to open it, you have to switch the machine off by turning the selector dial to «Off». After a few minutes the door can be opened (pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to press button 5 . At the end of the programme The machine stops automatically. If the «Rinse Hold» or «Night Cycle» option has been selected, the door remains locked to indicate that the water must be emptied out before opening the door. To empty out the water proceed as follows: 1. turn the programme selector dial to «Off» 2. select the Drain or Spin programme 3. reduce the spin speed if needed, by pressing the relevant button 4. press the button 5 to start the selected programme 5. at the end of programme, only the 6. 3 light illuminates. Turn the programme selector dial to «Off» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 16 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. [. . . ] Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance's rating plate. Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used. [. . . ]