User manual ZANUSSI ZWF1650

[. . . ] - - - - - - - - - - - - - - - - - - - - 19 Technical data- - - - - - - - - - - - - - - - - - - - - 22 Consumption values - - - - - - - - - - - - - - - - 23 Installation instruction - - - - - - - - - - - - - - - 24 Environmental concerns - - - - - - - - - - - - - 27 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green light of button 5 starts to flash. It can be turned either clockwise or anticlockwise. On position «O» the programme is reset and the machine is switched OFF. At the end of the programme the selector dial must be turned to position «O», to switch the machine off. 14 Select the delayed start by pressing button 7 This option permits to delay the start of the wash programme by 3, 6, 9 hours. Press this button repeatedly to select the required delay. You must select this option after you have set the programme and before you press the button 5. Cancelling the delayed start: You can cancel the delay time at any moment, before you press the button 5. If you have already pressed the button 5, and you wish to cancel the delay time, proceed as follows: set the washing machine to PAUSE by pressing the button 5; press the button 7 once, the light relevant to the selected delay goes off. press the button 5 again to start the programme. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 16 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: The drum should be empty of laundry. Select the hottest cotton wash programme. [. . . ] 2. Connect the hose with the angled connection to the machine. Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. Attention !Angle the hose to the left or right depending on the position of your water tap. [. . . ]