User manual ZEISS AXIO IMAGER STARTUP

[. . . ] Carl Zeiss START-UP Initial start-up Axio Imager 3. 1. 10. 2 Motorized stand · Plug connecting plug (3-12/2) of power supply 230 (3-12/3) into the corresponding connector (3-12/1) on the rear side of the stand. · Plug the power cable first into the power connector (3-12/4) of the power supply 230 and then into a power outlet. [. . . ] · Remove eyepiece and, in the pupil image visible in the eyepiece socket, center the lamp filament and its reflection with adjusting screws (3-14/4 and 5). · Using adjusting screws (3-14/3) optimize the evenness of illumination of the pupil image. It is advisable to use the adjusting aid (4-1/5) for fine adjustment of the halogen illuminator mounted to the reflected-light socket. After pulling out the adjusting aid, the lamp filament and its reflection can be viewed directly in its viewing glass. · Move the diffusion disk in and reinsert the filter wheels. B 46-0046 e 04/05 33 Carl Zeiss START-UP Attachments and conversions Axio Imager The reflective (coated) side (3-38/3) of the beam splitter has a beveled edge (3-38/1) or corner (3-38/2). · Place the excitation half of the module (3-37/1) onto the emission half (3-37/4) (retaining pins 3-37/5b and eyelets 3-37/5a mesh with one another). Hold both halves together and turn them back into the installation position. · Re-insert the slotted screws and tighten them up. Fig. 3-38 Marks on beam splitter · Finally, affix the adhesive label with the name of the filter combination to the side of the module. 3. 2. 10 Replacing the HAL 100 halogen lamp CAUTION Hot surface!You need not remove the lamp housing from the stand to replace the halogen lamp. Do not store the supplied tool for lamp replacement in the lamp housing while the illuminator is operating. The replacement lamp (3-39/8) may remain put on in the lamp housing. · Switch off the microscope as described in Section 4. 3, disconnect plug (3-13/7) from connector12 V/100 W (3-13/3 ­ reflected light or 3-13/5 ­ transmitted light) and allow for a cool down of approximately 15 minutes. · Depress unlock button (3-39/3) of halogen illuminator HAL 100 (3-39/1), fully pull out lamp carrier (3-39/2) and put it down separately. · Depress both spring levers (3-39/5) and remove the old halogen lamp (3-39/6) upward. Always hold/grasp the halogen lamp by means of the replacement tool (3-39/7), as even traces of grease on the lamp may affect its lifetime. · Depressing both spring levers insert the new Fig. [. . . ] · Plug the plug of the LED illuminator into the 12 V/100 W connector (transmitted light) on the back of the instrument. You can change the color temperature for specimen observation by inserting color temperature filters in the slider with diffusion disk (to be held by retaining ring). B 46-0046 e 04/05 51 [. . . ]