User manual ZELMER 880.5

[. . . ] Using new filtration system the appliance can work like traditional vacuum cleaner, or like vacuum cleaner with water filter. We created the possibility of choosing one of 5 dirtiness picking up systems, which can be applied depending on user's individual needs, including the possibility of paper bag usage. please read these instructions carefully. Pay your special attention to important safety instructions. [. . . ] Vacuuming with both water and paper bag. The dirtiness is accumulated inside the FOAM FILTER paper bag. , , GORETEX" filtration pad (white colour) applied inside the filter chamber prevents water infiltration to paper bag. After operation remove the water from the tank and dry it. Vacuuming with both water and "FIZELINA" filtration pad (black colour) without paper bag. The dirtiness is accumulated inside the filter chamber­ they are wet. Vacuuming with water without paper bag and filtration pads inside the filter chamber. When applying the above mentioned filtration system you can use the vacuum cleaner the following way: - Remove the front tank and take the filter out of the tank. - Release the hooks fastening the top lid with the filter housing, pressing simultaneously both hooks with your thumbs; see the figure beside (position1-1). - Bring the filter handle to vertical position , remove the top lid from the hooks and open the dust com. There are the paper bag fastening gaps inside the compartment: - Bend the paper bag along the bending line according to the arrow direction. - Turn the ending of the hose up to the position where the tops marks on the hose ending and tank cover each other and remove the hose from the tank. - Open the top lid and remove the front tank. - Remove the water filter and take the foam filter out of it. - If the rubbish have been collected to the paper bag before, please release the top cover hooks 1 following the above mentioned activities (Item"A"). - Pour dirty water out including the dirtiness form the tank and rinse the tank. - Pour clean water, insert the water filter, place the tank on the base and close the top lid. The float can also operate during sudden movements, sharp pulling, hitting, or crossing the doorsteps. In such case: - Switch the vacuum cleaner off for several seconds and then switch it on again and continue vacuuming. If you want to use your vacuum cleaner for liquid suction, please prepare it like for dry surface cleaning, apart from: 1. Front tank should be empty (without water). Do not apply any filtration pads or paper bag. [. . . ] Warranties good cleaning effect and proper vacuum cleaner operation, only using the cleaning agents and their amount approved by ZELMER S. , which is indicated at the label: - , , DYWANOPUC" cleaning powder manufactured by OKTIMA, Poland, - , , CARPEX" cleaning liquid manufactured by ASTRA POLLENA, Poland, - , , FOUNTAINHEAD" cleaning liquid manufactured by Butcher's, USA - Place the tank in previous place and push it in to fasten it exactly at the vacuum cleaner housing. Put a small amount of cleaning agent on white cloth (powder solution or liquid) and clean the carpet in the least visible place. If the cloth will be coloured, it means that the carpet does not have permanent colours and can not be cleaned this way. [. . . ]