User manual ZENEC ZEM-W701RM

[. . . ] this document is the detailed description of the software. You can easily discover ZENEC Navigation Software while you are using it; however, we still recommend that you read this manual to understand the screens and the features of ZENEC Navigation Software. 2 Entering an address if house numbering is restarted. 7 Deleting the next via point from the route . [. . . ] To run the simulation at normal speed and with voice guidance instructions , . The simulation can be aborted any time by tapping You do not need to pause the active route: when you start driving again, ZENEC Navigation Software restarts the voice instructions from your position. 7 Deleting the next via point from the route The easiest way to delete the upcoming route point (the next via point) is to open the Route Information screen by tapping the Turn Preview field () on the Map screen, and then tapping . The easiest way to delete the active route is to open the Route Information screen by tapping the Turn Preview field () on the Map screen, and then tapping You have another option. If via points exist in the active route, you cannot delete the route immediately on the Route Information screen. Enter a name for the saved route, and then tap When you save a route, ZENEC Navigation Software not only saves the route points but the whole itinerary: The saved route might have been influenced by TMC information. When you later use the route, it appears as it was saved. But if it needs to be recalculated, the current TMC information will be used in the new route. If you updated your map since you first saved the route, ZENEC Navigation Software recognises the change, and recalculates the driving instructions according to the latest available map information. ZENEC Navigation Software deletes from the route any via points that you already left behind during navigation together with the road segments used to reach it. To avoid this, if you want to save the route, you need to save it before you start navigating. ZENEC Navigation Software is connected to the GPS receiver, but the signal is too weak and the receiver cannot determine the GPS position. It indicates the following status information on a single strip: There are new, unread TMC events. a part of the route is bypassed based on TMC events. A part of the route is mentioned in TMC events but could not be bypassed (for example, the destination is on a congested street). There are two fields reserved on the Map screen to display the next two manoeuvres (route events that are listed in the Itinerary). both the type of the event (turn , roundabout , exiting motorway , etc. ) and its distance from the current GPS position is displayed. Most of these icons are very intuitive and you also know them as road signs. The following table lists some of the frequently shown route events. The same symbols are used in both fields: The number of the exit is shown in the circle, but only for the next turn. In certain situations when route events are not important, these fields show other useful pieces of information. [. . . ] 1 to duplicate the Software Product (to make a copy thereof); 7. 2 to lease, rent or lend it or to transfer it to a third person for any reason; 7. 5 to evade the protection of the Software Product or to modify, circumvent or obviate such protection through technological or by any other means; 7. 6 to modify, extend, transform the Software Product (in whole or in part), to separate it into parts, combine it with other products, install it in other products, utilise it in other products, not even for the purpose of achieving interoperability with other devices; 7. [. . . ]